Track Sensors detect a train at one point on a track. They can be used to light indicators, activate any of our bases, or trigger a growing variety of preset actions and animations.
Sensors are available that replace a single cross tie, bare-boards, or as individual components.
- HO, On30, and O scale plastic ties are sized to match typical track ties in each scale.
- Bare-Board sensors can be used below or between ties from Z to G scale.
- Do-It-Yourself kits have separate components for pre-ballasted track or special installations in any scale.


An installation in existing On30 Track. Next add caulk in the hole, then paint and ballast
Installing a Track Sensor Tie is simple in new or old track. A razor knife can cut any plastic attaching the chosen tie. Cut the spikes away, and then pull tie out from beneath the rails, sliding sideways for mounted track. Tie sensors are designed as an extended length switch-tie, projecting out to one side of the track. The hole for the attached flex-cable is drilled outside the track, below the extended tie. The cable is dropped into the hole, and the tie slid in beneath the rails.
Bare-board ties are 1/8″ width printed circuit boards with wires and mounted 401 optical transistors mounted for large, medium, or small gauges. These can be painted, and hidden between ties, or replacing ties in small scales.
For those that wish to use a detector but cannot accommodate the cross-tie design we offer a DIY option of two photosensors and a connecting cable. Housed in 3mm LED cases this may be easily wired together to fit awkward or unanticipated situations (soldering required).
Our sensors are based on the concepts presented in the 2016 MRH forum entry of Gooeff Bunza SMA23 – A New DCC & DC Car & Loco Detector .
Our sensors sense the shadow of any engine or rolling stock. Each track sensor reads the light from two locations, one between the rails and one outside the track. The two readings are constantly compared, instantly calibrating in any changing room light. If there is enough light to see your trains there will be enough to activate track sensors.
In dark tunnels some additional light may be needed. We offer a plug-in illuminator to make operation in dark tunnels easy.
Uncategorized